TACHO PROGRAMMATOR CD400

       Tacho programmer CD400 is designed for verification, calibration, and configuration of control devices. Basically, a Tachopgrapf is a device that measures and records the speed and distance driven by a vehicle. The data are recorded in the form of graphics on a paper disk. Tacho programmer CD400 calibrates and programs every analog and digital tachograph.

Supported
Analogs:
FTCO 1319, MTCO 1324/1390, KTCO 1314/1318, Motometer EGK100, TSU 1391, VR2400.

Digitals:
SmarTach, EFAS-4, SE5000 (Exakt Duo), DTCO 1381 (DTCO® 2.1 active).

Functions
W figure resolution on measuring record (beside optional photo-cell) or rolling path.
K figure measure proceeding KTCO 1314, KTCO 1318, and FTCO1319.
Parameter programming covers IMS (Independent Motion Signal) and VDO counter.
Speed simulation customizable automatic test diagram.
DTCS reading (Digital) and deleting.
The Sensor pairing 'KITAS activation.'
Clock efficiency analysis.
Workshop card's PIN recounting and input over CD400.

Advantages
No power connection neither battery charging is required; the tachograph itself powers the only tester.
User-friendly, clear four lines menus, no training required.
Small size, the most petite tachograph tester on the market.
The Automatic tachograph model detects power-on.
Double performance of the "W factor" measure proceeding track by catching half pulses.
The only tester can reset the odometer and change the sender type on the VR2400.
Flash program memory, easy software upgrade adopting a serial port or USB serial adapter on any PC.