PCMFLASH VERSION 1.3.0 RELEASED

PCMflash Update, Version 1.3.0.

A new module 89 "China MG1" has been added for working with MG1 family ECUs installed in Chinese-made vehicles. It supports reading, writing through the vehicle's diagnostic connector, and checksum verification and correction. Direct ECU connector connection may be required for reading (currently in pre-facelift Haval F7/F7x models). Available from April 13, 2023.

In module 30 "Kia/Hyundai SIM2K," support for SIM2K-241 ECU variants used in hybrid vehicles has been added. It includes reading (requires direct ECU connector connection), writing, and checksum verification and correction.

In module 32 "Ford Focus 3 2015, Ford Explorer 2016, Ford Kuga 2 2017," a test protocol for working with EMS2701 ECUs used in Ford hybrid vehicles has been added. It supports reading, writing, and checksum verification and correction.

Modules 36 "Kia/Hyundai EDC17" and 53 "Infineon Tricore BSL" now support AdBlue DCU17PC42/PC43 ECUs used in Kia/Hyundai vehicles. Module 36 supports reading, writing (after unlocking with modules 53 or 71) with direct ECU connector connection, and checksum verification and correction. Module 53 has added the ability to read the password from these ECUs.

Modules 50 "VAG EDC17 UDS," 53 "Infineon Tricore BSL," 71 "Bosch MEDC17 Bootloader" now have checksum verification and correction for additional monitoring areas used in ECUs with multiple calibration data sets. Previously, modifying these areas led to the ECU's cyclic reboot and prevented "recovery" through the diagnostic connector.

In module 58 "VAG DSG/CVT," support has been added for the latest revisions of DQ400 ECUs in service mode.

Module 61 "Kia/Hyundai CPGDSH/CPEGD" features improved checksum verification and correction of monitoring areas.

Module 80 "Denso SH725xx/1N83M Bootloader" has added support for new ECU types.

Module 81 "JLR Gearbox" includes a test protocol for Aisin AWF21 automatic transmission ECUs. It supports reading, writing, and checksum verification and correction.

Module 83 "VAG Bosch DQ380/DQ381/DQ500/ZF 8HP" adds test support for Aisin AL600/AL750/AQ250 automatic transmission ECUs working via K-Line. It supports reading, writing, and checksum verification and correction.

In module 84 "VAG Delphi DCM6.2," the ability to read DCM6.2 ECUs directly from their connector has been added.

These are some of the notable changes in this PCMflash update.