PCMFlash has released version 1.2.4.
1 December 2021
- Added a new module 79 "Mitsubishi CAN-bus Bootloader," designed to work with Mitsubishi ECUs in various car brands on the bench. Supports reading, writing, checking, and correcting checksums.
- Added a new module 80 "Denso SH725xx Bootloader," designed to work on the bench with Denso ECUs using SH725xx series microcontrollers. Supports reading, writing, checking, and correcting checksums.
- Added a new module 81 "JLR Gearbox," designed to work with Bosch ECUs for JLR vehicles with 6HP, 8HP automatic transmissions through the car's diagnostic connector. Supports reading, writing, and checksum correction.
- In module 8 "Mazda Generation 1," added support for Denso ECUs used in the US market with LF engines. Supports reading, writing, and checksum correction.
- In module 57 "SIMOS 8/10/11/12/PCR2.1," added support for SIMOS12.1/SIMOS12.2 ECUs. Supports virtual reading, writing through the car's diagnostic connector, and checksum verification and correction.
- In module 68 "JLR Denso," added support for another protocol for Denso ECUs installed in Range Rover vehicles. Supports reading, writing, checksum verification, and correction.
- In module 69 "Mercedes-Benz MED17/EDC17," added support for ME9.7 ECUs used with M156, M272, M273 engines. Supports reading and writing calibrations, checksum verification, and correction.
- In module 77 "Bosch ME9/MED9/EDC7/EDC16/PSG16/TCU Bootloader," added full support for EDC7 ECUs, including EDC7C1 and EDC7C3, as well as RE5RO5A, 6HP automatic transmission ECUs of various modifications, A5SR1/A5SR2/A6GF1.
- Added the ability to use automatic power management on the bench when working with "OBD" modules.
- Added a new setting to reduce communication speed where possible.
- Other useful changes and necessary fixes.